Windows Xp Error After Replacing Motherboard

Motherboard is the main circuit board, which contains"STOP 0x0000007B INACCESSIBLE_BOOT_DEVICE"
all the basic circuitry and components of theIDE controller difference may not let the system to
computer system. The main components ofstart. In order to resolve this issue, we need to
motherboard include memory, BIOS, microprocessor,check whether the new IDE controller is detecting
mass storage device interfaces including hard drive,the hard drive size as the same as was detected by
interconnecting circuitry, expansions slots, serial andprevious IDE controller or not.
parallel ports and the controllers which control- If the new IDE controller is detecting the hard drive
peripheral devices. All the chips collectively formas the same size, we need to carry out in-place
chipset.upgrade (reinstallation) of Windows XP.
An IDE or Integrated Drive Electronics controller is- However, if the size doesn’t come out to be
what acts as an interface betweensame, we need to repartition and format the hard
motherboard’s bus or data paths and thedrive and then reinstall Windows XP operating
computer storage device, such as hard drive. Today,system. It requires the data to be backed up first to
for EIDE or IDE hard drives, IDE controllers are stillavoid Data Recovery requirements.
there on the motherboards.Data that gets lost due to formatting still remains on
If the motherboard is replaced in a Windows XPthe hard drive’s data area, if it has not been
system, this is needed that the replacedoverwritten. So if the backup has not been taken or
motherboard must contain the IDE controller that hasif it fails, Data Recovery Software can recover lost
the same chipset as of the earlier used motherboard.data. These Data Recovery Software use powerful
However, if they differ, Windows XP may prompt anscanning algorithms which examine the failed hard
error when you start the computer system afterdrive and help extracting the possible lost information.
motherboard replacement: